MK484 AM radio circuit

Subscribe by email

Very simple, sensitive and high quality AM radio circuit can be make with MK484 monolithic integrated circuit with very few external components.
This MK484 AM radio circuit provides a complete solution including : RF amplifier, Detection and AGC circuit (automatic gain control ), which requires only a few external components to give a high quality AM Tuner.
No setting up or alignment is required and the circuit is completely stable in use.
The circuit has an input impedance of 4Mohms and operates over a frequency range of 150KHz to 3MHz. The IC will run with DC supply between 1.1V and 1.8V typical 1.4V and a current drain of 0.3mA makes it suitable for battery operation.
The output signal is to low to drive a speaker ( typical from 40 to 60 mV ) and is necessary a audio power amplifier .
The coil needs approximately 55 turns of 0.315mm diameter enamelled copper wire on a 100mm long ferrite rod.

Circuit Diagram: 
MK484 AM radio circuit design

Comments

Post new comment

The content of this field is kept private and will not be shown publicly.
CAPTCHA
This question is for testing whether you are a human visitor and to prevent automated spam submissions.
Image CAPTCHA
Enter the characters shown in the image.

Circuit Diagram
9V fm transmitter circuit 9V fm transmitter circuit design using transistors

This fm transmitter circuit is a very simple and require few external components and operates in...

TDA7000 fm radio circuit design TDA7000 fm radio circuit

This fm radio circuit is designed using TDA7000 fm radio integrated circuit and a minimum of...

Car tracking device circuit
car tracking device circuit diagram transmitter
car tracking device circuit diagram receiver

This car tracking device circuit can be used to locate car in a parking or other objects and is...